| 影音天地主旨 ﹝請按主旨作出回應﹞ |
|
寄件者 | 傳送日期
|
| [#1] 我的conrad johnson premier one 噴火暴斃 已使用十多年, 以前經常燒電阻, 換了蘇聯膽後已多年無傷風鼻塞. 昨夜突然機底爆出火光, 一枝膽發紅, 其他膽的偏壓燈仔也全著. 看來救番都元氣大傷 雖然我有一部counterpoint後級做後備, 但聽慣 P1 的味道, 而且多年伙記突然瓜柴, 真係心中戚戚然, 不過屋企無火燭, 都算好彩 |
yip2133 會員218.xxx.xxx.24 |
2010-02-08 01:02 |
 Audio Link 盤點清貨大特價 |
||
| [#2] 我的conrad johnson premier one 噴火暴斃 Premier One不但力大無窮，而且聲底厚潤甜美。多年前有機會係一間二手鋪聽Premier One，佢係未run in既情況下一開聲就KO咗一部唱左一段時間既Goldmund後級，威力大到嚇我一跳！ 咁師兄你就大劑咯，聽慣左Premier One好難聽返其他機。  |
iloveu 會員 218.xxx.xxx.96 |
2010-02-08 01:37 |
| [#3] 我的conrad johnson premier one 噴火暴斃 Premier One＞正式是老馬有火,非同凡響! |
joey19652008 會員 218.xxx.xxx.117 |
2010-02-08 09:27 |
| [#4] 我的conrad johnson premier one 噴火暴斃 主要是燒偏壓電阻，應該可以修理好的。 |
accphoto 會員 220.xxx.xxx.56 |
2010-02-08 11:56 |
| [#5] 我的conrad johnson premier one 噴火暴斃 以前燒電阻, 煙火全無, 祗會著燈仔. 今次大鑊好多 我諗樂民應該整得掂, 但佢地應該唔會幫我更新老化零件. 各位師兄有無好提議? |
yip2133 會員 218.xxx.xxx.24 |
2010-02-08 12:41 |
| [#6] 我的conrad johnson premier one 噴火暴斃 呢度大把 整 胆機高手, rcwy, dd845, timtube hing 其一二 |
254mm 正式會員 203.xxx.xxx.136 |
2010-02-08 12:44 |
| [#7] 我的conrad johnson premier one 噴火暴斃 不如比返代理雅典龔師傅整，佢一定系CJ專家。 |
dcman 會員 61.xxx.xxx.174 |
2010-02-08 14:06 |
| [#8] 我的conrad johnson premier one 噴火暴斃 yip2133 hing, please check PM |
嚦嚦二世 會員 203.xxx.xxx.126 |
2010-02-08 14:21 |
| [#9] 我的conrad johnson premier one 噴火暴斃 我之前拎部poweramp返雅典龔師傅整都唔係收好貴不過龔師傅 好似冇做啦. |
jr 會員 219.xxx.xxx.207 |
2010-02-08 14:25 |
| [#10] 我的conrad johnson premier one 噴火暴斃 If the output transformer(s) is not burnt out, the amp can be repaired at reasonable cost. AVwalkman has the pickup facility, there is no need for you to take it to Fo Tan. |
alexanderkoo 正式會員 203.xxx.xxx.149 |
2010-02-08 17:25 |
| [#11] 我的conrad johnson premier one 噴火暴斃 睇下都知勁,倒相級打孖泥,輸出三對。 輸出係咪真係用EL34架?不過EL34我(唔玩膽的人)聽過,係一隻好力(最好力又唔係)又幼細嘅膽。  |
etsang3 會員 202.xxx.xxx.193 |
2010-02-08 18:26 |
| [#12] 我的conrad johnson premier one 噴火暴斃 "".....一枝膽發紅, 其他膽的偏壓燈仔也全著...."" 似冇左偏壓，獨立偏壓線路最怕發生的事。 |
thomasc2 會員 61.xxx.xxx.176 |
2010-02-08 21:25 |
| [#13] 我的conrad johnson premier one 噴火暴斃 第一件事我會check D24 枝IN4007。 |
thomasc2 會員 61.xxx.xxx.176 |
2010-02-08 21:27 |
| [#14] 我的conrad johnson premier one 噴火暴斃 P1 is using 6550 rather than EL34. After new year I will open it up and see what I can do. It is frustrating for a 120 lb monster. |
yip2133 會員 218.xxx.xxx.24 |
2010-02-09 00:40 |
| [#15] 我的conrad johnson premier one 噴火暴斃 有時C20-C25果D電容有漏,會抬高bias"負"壓,咁隻膽就會"紅"架。我整VTL果陣踫過。(圖中黃色果兩粒) http://i20.photobucket.com/albums/b206/etsang3/VTL%20Deluxe%20225e/7723bbf5.jpg |
etsang3 會員 202.xxx.xxx.193 |
2010-02-09 08:40 |
| [#16] 我的conrad johnson premier one 噴火暴斃 但是它""突然機底爆出火光""和全部大膽偏壓都突然出現問題就唔似是交連電容(C20 - 25)漏電，六粒交連電容同時出事機會不大。 |
thomasc2 會員 61.xxx.xxx.176 |
2010-02-09 11:04 |
| [#17] 我的conrad johnson premier one 噴火暴斃 只要唔係燒左輸出牛,應該好易整返. |
dchung 會員 203.xxx.xxx.226 |
2010-02-09 11:40 |
| [#18] 我的conrad johnson premier one 噴火暴斃 識就不難, 就算牛燒了, 咪番繞 lol, 至多D 聲走哂樣, 另一回事, |
254mm 正式會員 203.xxx.xxx.135 |
2010-02-09 11:50 |
| [#19] 我的conrad johnson premier one 噴火暴斃 Yip 我睇多數都係燒電阻多.你conrad johnson premier one 的確係一部好機,我都層擁有one同one.B.亦和我度過3年之久,現小弟有一些經驗希望能和你分享.premier one (一)係一部好怕潮濕機種,如耐無開機,最好先用風筒吹果12支膽約3-4分鐘,其實系電阻先真怕因受潮好容易燒機.(二)每次開機先看12粒偏壓燈會否著紅燈,如有著紅燈要立即關機,再用風筒吹向著燈之電阻約1分鐘.然後開機再睇有無著紅燈.如無紅燈著可正常開機.還有如何較膽偏壓問題容係再講. 最後修改時間: 2010-02-10 23:50:26 |
林po 會員 221.xxx.xxx.161 |
2010-02-10 23:41 |
| [#20] 我的conrad johnson premier one 噴火暴斃 有時C20-C25果D電容有漏,會抬高bias"負"壓,咁隻膽就會"紅"架。我整VTL果陣踫過。(圖中黃色果兩粒) X2 |
audiofans 會員 116.xxx.xxx.42 |
2010-02-11 00:27 |
| [#21] 我的conrad johnson premier one 噴火暴斃 睇情況真喺好大機會無左偏壓，4支穩壓zener 1N5251B都需要check下。 |
smith 會員 210.xxx.xxx.27 |
2010-02-11 11:10 |
| [#22] 我的conrad johnson premier one 噴火暴斃 其實zener仔係有一定壽命，到時候就會打柴，部機太多穩壓係捱唔到幾十年的。 |
smith 會員 210.xxx.xxx.27 |
2010-02-11 11:24 |
| [#23] 我的conrad johnson premier one 噴火暴斃 Dear Mr Lam PO If I heard your suggestion earlier I should have escaped from this fate. Thx for all informations from all you good guys. May I wish yu all the best in New year and Kung Hei Fat Choi P Yip |
yip2133 會員 218.xxx.xxx.24 |
2010-02-11 21:47 |
| [#24] 我的conrad johnson premier one 噴火暴斃 Unreliable 幾好聲都冇用! |
軍城 會員 112.xxx.xxx.97 |
2010-02-11 22:19 |
| [#25] 我的conrad johnson premier one 噴火暴斃 Time is really running fast. It is four months from the date of death of P1. I have brought it to a famous shop for repair. It takes two months to fix the problem. After the fixation I plugged it into my system. You know what happen? The OTHER side was not working. I don't know what they had done to my P1. And I sent it back. Now it is another 2 months and I am still waiting. !@$%^&**( At the same time my good freind with P1 have same problem of blowing in humid time. I decide to give it up. Not only because it is fragile, but also because I am too fed up with handling this 120 lb monster and spending hours in connecting the triwire.... I am now using biamp to drive my ATC speaker. Countepoint 400 and Arcam 555. I need to abmit that sound of P1 is addictive and I am still trying to adapt to the cleaner but dryer sound. |
yip2133 會員 203.xxx.xxx.29 |
2010-06-21 08:30 |
| [#26] 我的conrad johnson premier one 噴火暴斃 It is a nice equipment ,, i was luckily to hear it in one R33 member,, still love it ... |
rf2899 會員 116.xxx.xxx.24 |
2010-06-21 11:40 |