用緊elekit tu879推o記迷你版，用跟机EH6L6出來既人聲已經好正，後來換了纯銀過机線及喇叭線，就更加無得頂，對喇叭用左差不多十年，箱既外觀只係插座同名牌有氧化，其余都保持得好好(單元既皮边都係)

最後修改時間: 2015-02-04 20:39:56

i also step into this family and using single ended tube amp to drive. sound nice

YC...thanks so much for the info.
Will have a look of the stand :)

hktonyng hing,
I really don't know which amp. to recommend. Mine is a tailor made one. By the way, just notice 旺角秋葉原 still has Foundation 18" speaker stand. Maybe suitable for you.

YC hing:

re: "I like the 211 or 845 based SE amps)"

Which 211/846 SE amps do you recommend?

KHFC - Tony :)

I listened to the Orgue reference at Carryon driven by Maranz 9 (el34 pp). The sound is very nice, with solid and big soundstage. It does not sound raw even comparing to my own set up with VT-25 sunaudio driving P-610ma. That's why sometime later I bought p-610s based on my audition that time.

My experience is that at low frequency, the Orgue (not the diatone) p610s showed some signs of uncontrollable excursion, but when i heard it at Carryon showroom at high listening level, it did not show this phenomenon, so I could only contribute this to burn-in, or the newer orgue needs higher damping somehow...

ckl2 hing,

Kung Hei Fat Choi to you too.

I am not saying Nuforce is better than all the tube amp out there, but it is better than all the tube amps I have listened and owned. Yes, V3 is much better than v2. And v2 is much better than all the tripath I have owned. I can't imagine how V3 can get better. My only possible upgrade is going for the Nuforce Stereo 8.5 or monoblock but then I don't need that much of power.

A few people came to listen to the nuforce v2 before i changed to v3. One experienced friend said the Nuforce sounded very nice, and to have a tube amp that sound that nice it would be much more $$$$$ with very nice tran and tubes etc. So poor guy like me only need Nuforce. :P

audiowen c-hing:

The nominal resistance of p610ma is 16 ohm. On MC240, there is a range of output choices regarding speaker ohm, i.e. 4, 8, 16,...etc. Which output speaker ohm on M240 you found it best match with p610ma? Exactly 16 or other choices?

Cheers!

Hi welborne,

KHFC! Do you mean v3 is the best sound?

I gave up tube, now onto Nuforce, firstly v2, now v3.

Well i do miss the Diatone/Orgue sound. Wonder how they perform on my Open baffle...

I like the 211 or 845 based SE amps. :-)

too bad I sold all my diatone p610ma and mb, and even my orgue P-610s. In my opinion. the Orgue is very well made, a real step ahead of the p610ma in some area but not all. I would not say p-610s has all the sound of p-610ma/b, but it is a nicer driver for a wider type of music. But I feel the Orgue needs a lot of time to run in to soften the leather surround.

恭喜各位大哥新春大吉, 鴻運當頭, 恭喜发财.
wanfai

I am P610ma user. SE amp and PP amp sounds different but both are good. I try my DIY 2A3, MC240. some time I prefer 240, it is more colorful.


The 610 bass MUST better than 3/5A...

YC hing:

Which SE amp do you recommend for Orgue Diatone?

Thanks!

I still have a pair of the Pioneer P610 to play with...:-)

I suggest to try some Single ended tube amp with it. It is a waste not to try full range with these amps.

中音單體是mini-Zenith喇叭的靈魂，征宇特別選用經典（甚至以可說是傳奇）的Diatone P-610 Signature全音域單體，這支著名全音域單體的頻率響應範圍是55Hz到20kHz，mini-Zenith讓它由355Hz～15kHz之間的寬廣頻率全頻段發聲，其上和其下才分別加上超高音與低音單體。355Hz～15kHz這段頻域幾乎已經含括了人聲與絕大多數樂器的發聲範圍，排除分音元件的影響後，可以發出極為精準的音色與相位。

在15kHz以上到40kHz，Mini Zenith補上一顆暱稱為「尖鼻子」、許多昂貴喇叭都一致採用的Scan-Speak R2904高音（實際上已經當成超高音使用了），這顆單體的背面結構十分特殊，相信看過的朋友並不多。

咦，前障板上不是只有兩個單體嗎？怎麼又冒出一個低音單體？原來mini-Zenith將低音單體安置在箱體底部向下發聲，由這顆Scan-Speak紙盆低音單體26W8861負責355Hz～30Hz的頻率範圍。去年的mz-L1喇叭稱為「延伸型全音域揚聲系統」（Extended Full-Range Loudspeaker System），今年的mz-L2則稱為「空氣懸吊密閉式全音域揚聲系統」（Acoustic Suspension Full-Range Loudspeaker System），兩者有什麼不一樣嗎？其實mz-L1同樣是密閉式設計，不過mz-L2進一步設計讓內部空氣「等溫壓縮」，陳醫師說可以讓低音的細節與層次更分明。

this taiwan brand designer uses the Orgue p610s as the main driver in his flagship loudspeaker model.

http://www.hi-av.net/modules/article/view.article.php?140