兩聲道
CD機 | MD機 | SACD機 | DAC | CAS | 合拼擴音機 | 前級擴音機 | 後級擴音機 | 接線 | 喇叭線 | 揚聲器 | 耳機 | 耳機擴音機 | LP產品 | 膽機產品 | 開卷式錄音機 | 音響配件 | DIY音響 | 電源 | 家庭影院
電視機 | 投影機 | 錄影機 | DVD影碟機 | Blu-ray影碟機 | 多媒體播放器 | 機頂盒 | 多聲道擴音機 | 多聲道揚聲器 | 多聲道影音組合 | Mini音響組合 | 重低音揚聲器 | 輔助設備 | 同好會
同好會 | Accuphase | B&W | Burmester | Denon | Jadis | KEF | KRELL | Luxman | Marantz | Nuforce | OPPO | Pioneer | TEAC | WEISS | News
News | Blog | 其他
其他 | 所有 |
| 影音天地主旨 ﹝請按主旨作出回應﹞ 上頁 首頁 | 寄件者 | 傳送日期
|
| [#41] 胆机唔接喇叭開机 好多廠機應有先見, 已落pre loading, 不過聲可能差D |
frank 正式會員116.xxx.xxx.190 |
2011-06-22 10:02 | |
|
|
|||
| [#42] 胆机唔接喇叭開机 我都燒過電源牛,燒過逆流圈. 當年焊機後,檢查不仔細就著機所至. 唯有買過隻換上,當時有點可惜,卻樂此不疲地玩到現在. |
k.c 正式會員 119.xxx.xxx.254 |
2011-06-22 10:04 |
| [#43] 胆机唔接喇叭開机 今次係 "要面, 死頂". |
tvc 正式會員 1.xxx.xxx.173 |
2011-06-22 10:04 |
| [#44] 胆机唔接喇叭開机 我都燒過電源牛,燒過逆流圈. 當年焊機後,檢查不仔細就著機所至. 唯有買過隻換上,當時有點可惜,卻樂此不疲地玩到現在. ------------------------------------- 唯有祝你日日都咁快樂  |
waterman 正式會員 202.xxx.xxx.143 |
2011-06-22 10:08 |
| [#45] 胆机唔接喇叭開机 認燒牛係"要面,死頂",新名詞. 不如你話想我點? 我認為ok就不妨順下你意. |
k.c 正式會員 119.xxx.xxx.254 |
2011-06-22 10:22 |
| [#46] 胆机唔接喇叭開机 """""初級部份winding 燒左，形成部份短路，即是初級線圈少咁截，亦未嘗不可。 ----------------------------------------------- 可能係有, 但有冇親身試過先? """" 輸出牛唔多覺，但我有部切割機就明顯試過兩次燒到出煙，以為衰硬，但攤凍後開機又行番，情況照計差唔多。 """"How about solid state amp. Is it ok without connect to spk?"""" For ss amp without output transformer, keeping the speaker output open is fine. However, it is extremely dangerous if you short the output. If the amp is not short circuit protected or if there is something wrong with the protection device, it will blow the amp almost instantly. 最後修改時間: 2011-06-22 10:48:57 |
thomasc2 正式會員 61.xxx.xxx.176 |
2011-06-22 10:36 |
| [#47] 胆机唔接喇叭開机 ... 最後修改時間: 2011-06-22 10:49:17 |
thomasc2 正式會員 61.xxx.xxx.176 |
2011-06-22 10:48 |
| [#48] 胆机唔接喇叭開机 小弟想請教: 不接音源來著機煲新膽又有否問題? 因在MK添X6/F常帮客這樣煲机煲膽,仲會煲過夜tim! |
hc21924900 正式會員 220.xxx.xxx.118 |
2011-06-23 15:23 |
| [#49] 胆机唔接喇叭開机 因在MK添X6/F常帮客這樣煲机煲膽,仲會煲過夜tim! no，佢在output位加左粒8ohm大功率電阻架 |
mr-chan 正式會員 113.xxx.xxx.49 |
2011-06-23 16:21 |
| [#50] 胆机唔接喇叭開机 唔接音源, 非唔接負載, 唔同野. |
k.c 正式會員 119.xxx.xxx.254 |
2011-06-23 17:08 |
| [#51] 胆机唔接喇叭開机 Derek hing, How about OTL tube amp without cow cow? I need to disconnect the speaker wires to check offset. |
dkyyu 正式會員 210.xxx.xxx.23 |
2011-06-23 17:20 |
| [#52] 胆机唔接喇叭開机 Thx Mr.Chan & k.c兄,又學到嘢! |
hc21924900 正式會員 220.xxx.xxx.118 |
2011-06-23 17:21 |
| [#53] 胆机唔接喇叭開机 This is an interesting discussion. Cannot believe having the amplifier power on but the speaker cables are not connected ^_^. Super high hand. |
Kenny 正式會員 146.xxx.xxx.21 |
2011-06-23 17:45 |
| [#54] 胆机唔接喇叭開机 How about OTL tube amp without cow cow? I need to disconnect the speaker wires to check offset. _________________________________________________ Dennis, no cow cow, just look at it as SS. Like thomas said, don't short the outputs. As for the offset, no worries. To check the offset, your aim is to achieve zero volt potential between the output terminals, whether there's any load shouldn't make any difference. That's how theory goes, mind you I never own or use any OTL myself. |
Derek2A3 正式會員 116.xxx.xxx.209 |
2011-06-24 00:10 |
| [#55] 胆机唔接喇叭開机 旦會老化 |
tingmoon 會員 219.xxx.xxx.137 |
2024-11-11 12:51 |
| [#56] 胆机唔接喇叭開机 小你老尾, 成9日推7埋晒D垃圾貼, 收皮啦! 福佳丁滿! 我等睇 日日好L好人撐你! |
CodyChan 會員 203.xxx.xxx.82 |
2024-11-11 13:50 |
