兩聲道
CD機 | MD機 | SACD機 | DAC | CAS | 合拼擴音機 | 前級擴音機 | 後級擴音機 | 接線 | 喇叭線 | 揚聲器 | 耳機 | 耳機擴音機 | LP產品 | 膽機產品 | 開卷式錄音機 | 音響配件 | DIY音響 | 電源 | 家庭影院
電視機 | 投影機 | 錄影機 | DVD影碟機 | Blu-ray影碟機 | 多媒體播放器 | 機頂盒 | 多聲道擴音機 | 多聲道揚聲器 | 多聲道影音組合 | Mini音響組合 | 重低音揚聲器 | 輔助設備 | 同好會
同好會 | Accuphase | B&W | Burmester | Denon | Jadis | KEF | KRELL | Luxman | Marantz | Nuforce | OPPO | Pioneer | TEAC | WEISS | News
News | Blog | 其他
其他 | 所有 |
影音天地主旨 ﹝請按主旨作出回應﹞ | 寄件者 | 傳送日期 |
[#1] DIY 喇叭電阻問題 HI 各位師兄, 現DIY 對喇叭, 但發現兩隻底音單元的電阻分別吾相同, 它標示8 ohm, 但度到一隻係6.2 ohm , 另一隻 5.6 ohm, 與8 ohm 相差好多, 正常嗎? 還有我是否需要額外加電阻去平衡聱音大小? 麻煩大家幫忙. 謝謝! |
yeungch903 正式會員 221.xxx.xxx.13 |
2020-04-27 22:08 | |
|
[#2] DIY 喇叭電阻問題 一般情況下唔需要,隻 driver voice-coil resistance ~5.7 ohms。 http://www.seas.no/images/stories/vintage/pdfdataheet/h0702_t14rcyp-h.pdf 最後修改時間: 2020-04-27 22:38:23 |
長長影子 正式會員 165.xxx.xxx.80 |
2020-04-27 22:36 |
[#3] DIY 喇叭電阻問題 8ohm is impedance (AC resistance), it also includes the measure frequency so it is normal. |
41450686 正式會員 61.xxx.xxx.216 |
2020-04-28 00:00 |
[#4] DIY 喇叭電阻問題 明白,真的吾該兩位,Thank you! |
yeungch903 正式會員 14.xxx.xxx.191 |
2020-04-28 00:12 |
[#5] DIY 喇叭電阻問題 明白,真的吾該兩位,Thank you! |
yeungch903 正式會員 14.xxx.xxx.191 |
2020-04-28 00:12 |
[#6] DIY 喇叭電阻問題 相差直流电阻10%,又少d 喎 |
254mm 正式會員 1.xxx.xxx.55 |
2020-04-28 08:57 |
[#7] DIY 喇叭電阻問題 我想指一个5.6ohm , 另一个可能5.8或5.9ohm 咋 最後修改時間: 2020-04-28 09:20:51 |
254mm 正式會員 1.xxx.xxx.55 |
2020-04-28 09:19 |
[#8] DIY 喇叭電阻問題 數值誤差可能出自量度儀器,樓主可以試下度多幾次看看係咪都出返相同數值。因為通常度低電阻他錶誤差比較大。 |
DYreal 正式會員 119.xxx.xxx.115 |
2020-04-28 09:25 |
[#9] DIY 喇叭電阻問題 仲要量度的時候,唔好用手㩒㩒下個喇叭振盆。 |
mcc2018 會員 218.xxx.xxx.114 |
2020-04-28 09:34 |
[#10] DIY 喇叭電阻問題 Re Measured in ohms (Ω), this is the DC resistance (DCR) of the voice coil, best measured with the cone blocked, or prevented from moving or vibrating because otherwise the pickup of ambient sounds can cause the measurement to be unreliable. Re should not be confused with the rated driver impedance, Re can be tightly controlled by the manufacturer, while rated impedance values are often approximate at best. American EIA standard RS-299A specifies that Re (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8 ohm drivers have resistances of ~5.5 ohms, and proportionally lower for lower rated impedances. https://en.wikipedia.org/wiki/Thiele/Small_parameters |
長長影子 正式會員 165.xxx.xxx.80 |
2020-04-28 09:56 |
[#11] DIY 喇叭電阻問題 跟據以往經驗,大廠喇叭 driver 出貨 DCR tolerance 大概+/-5%,普通大概+/-10%。 |
長長影子 正式會員 165.xxx.xxx.80 |
2020-04-28 10:05 |
按照傳送日期顯示:由舊至新 由新至舊 |