兩聲道
CD機 | MD機 | SACD機 | DAC | CAS | 合拼擴音機 | 前級擴音機 | 後級擴音機 | 接線 | 喇叭線 | 揚聲器 | 耳機 | 耳機擴音機 | LP產品 | 膽機產品 | 開卷式錄音機 | 音響配件 | DIY音響 | 電源 | 家庭影院
電視機 | 投影機 | 錄影機 | DVD影碟機 | Blu-ray影碟機 | 多媒體播放器 | 機頂盒 | 多聲道擴音機 | 多聲道揚聲器 | 多聲道影音組合 | Mini音響組合 | 重低音揚聲器 | 輔助設備 | 同好會
同好會 | Accuphase | B&W | Burmester | Denon | Jadis | KEF | KRELL | Luxman | Marantz | Nuforce | OPPO | Pioneer | TEAC | WEISS | News
News | Blog | 其他
其他 | 所有 |
影音天地主旨 ﹝請按主旨作出回應﹞ 下頁 尾頁 | 寄件者 | 傳送日期 |
[#49] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 阿香下次,回覆十幾年前六合彩開彩號碼tim. |
徐福 正式會員 58.xxx.xxx.215 |
2020-04-20 08:02 | |
|
[#48] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 佢畀條骨妹搞到心理有問題 |
louis9968 正式會員 58.xxx.xxx.219 |
2020-04-20 02:39 |
[#47] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 佢唔係正常人,你同佢講道理,太沒道理了。 |
254mm 正式會員 1.xxx.xxx.55 |
2020-04-19 20:21 |
[#46] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 a師兄我覺得如果你真係有心想幫幫啲後輩提供你寶貴嘅意見,噉麻煩你回答近一個禮拜其他師兄遇到嘅問題。而唔係回答十幾廿年前人哋問嘅問題,唔好話部機仲響唔響度,分分鐘連人都唔響度。 音響呢個行業都開始慢慢衰退,你唔出一分力都算喇仲不斷喺度搞破壞。如果真係好得閒嘅話不如去墳場同嗰啲住戶傾下偈好過啦。 |
DYreal 正式會員 119.xxx.xxx.115 |
2020-04-19 14:19 |
[#45] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 骨妹話冇水冇connect. |
龍虎豹 會員 14.xxx.xxx.227 |
2020-04-19 10:04 |
[#44] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 Poor connection |
aheung 會員 219.xxx.xxx.1 |
2020-04-19 09:47 |
[#43] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 thank you |
mps678 正式會員 59.xxx.xxx.193 |
2009-01-25 23:15 |
[#42] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 mps678 Hing, Very easy la. 甩晒d電源插頭d水線, TV signal 照舊接上就OK. ( 因為..your system will connect to Ground via TV signale cable. ) @_@ |
PLL 正式會員 219.xxx.xxx.128 |
2009-01-25 21:16 |
[#41] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 Dear Lo Yan Kap, You are right. the Hum---Hum noise disappeard when I disconnected the TV signale cable. How can I remedy it without disconnected the TV cable. Thank you |
mps678 正式會員 59.xxx.xxx.193 |
2009-01-25 20:29 |
[#40] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 thank you for the valuable advice, I will try to see if it is related to TV or the input. Thank you. |
mps678 正式會員 59.xxx.xxx.193 |
2009-01-21 07:36 |
[#39] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 UNPLUG晒所有INPUT,將INPUT SHORT入地睇仲有無聲啦! |
落雨路 正式會員 61.xxx.xxx.57 |
2009-01-21 00:01 |
[#38] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 可 能 SIGNAL-TO-NOISE RATIO 唔 夠 ......... A-WEIGHTED SIGNAL-TO-NOISE RATIO 100dB below rated output http://www.mcintoshlabs.com/products/mcintosh-mc2102-vacuum-tube-power-amplifier.asp |
沙田超人 正式會員 221.xxx.xxx.220 |
2009-01-20 23:20 |
[#37] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 落雨路hing, you are right. not 亂up, it is a fact, is a true, is a real. |
hififs 正式會員 218.xxx.xxx.194 |
2009-01-20 22:58 |
[#36] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 最近聽某有電子底的發燒友講,吾係講笑的,那si si聲越大,你amp越勁! 大概原因是,如喇叭的磁體較大,如Horn的大driver的大磁(16,000gauss or above) 與amp連繫時,喇叭是"如狼似虎"地"渴求" 必v,如果你amp是勁的話,就會有很大的si si聲,如果amp無料,就聽唔到! 亂up... |
落雨路 正式會員 61.xxx.xxx.57 |
2009-01-20 22:51 |
[#35] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 呢個係從電視天線引入的hum聲,你部av amp應有接dvd機 or hdmi引入再到電視,rf雜訊就直到你部av amp, |
路人茂 正式會員 119.xxx.xxx.242 |
2009-01-20 22:32 |
[#34] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 hiphopzz, Call me at 94872782 before 2300 hr or tomorrow |
mykl 正式會員 218.xxx.xxx.10 |
2009-01-20 22:32 |
[#33] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 Hifil 71, Call my phone 94872782 |
mykl 正式會員 218.xxx.xxx.10 |
2009-01-20 22:30 |
[#32] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 I used my AV intergated AMP to drive the 5,1 channel and there is no pronlem for all speakers. When I use the intergated AMP as a pre-amp to drive the font speaker as I used the pre-out from the intergarted AMP to connect to the input of the power AMP. Then the font speaker with HUM.....HUM. It will not disappear even I turned off the intergated AMP with the power AMP remain turned on. Any one know the problem. It just happed recently. |
mps678 正式會員 59.xxx.xxx.193 |
2009-01-20 22:13 |
[#31] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 高音聽到“斯斯聲”或低音有hum是同一道理,屏蔽問題,唔關部機勁唔勁! |
路人茂 正式會員 119.xxx.xxx.242 |
2009-01-20 21:49 |
[#30] 一開後級,喇叭高音為甚麼會有絲絲聲。。。 請用中文發言。。。謝謝。。因為本人不會英文。。 |
hifi171 正式會員 218.xxx.xxx.20 |
2009-01-20 21:25 |