兩聲道
CD機 | MD機 | SACD機 | DAC | CAS | 合拼擴音機 | 前級擴音機 | 後級擴音機 | 接線 | 喇叭線 | 揚聲器 | 耳機 | 耳機擴音機 | LP產品 | 膽機產品 | 開卷式錄音機 | 音響配件 | DIY音響 | 電源 | 家庭影院
電視機 | 投影機 | 錄影機 | DVD影碟機 | Blu-ray影碟機 | 多媒體播放器 | 機頂盒 | 多聲道擴音機 | 多聲道揚聲器 | 多聲道影音組合 | Mini音響組合 | 重低音揚聲器 | 輔助設備 | 同好會
同好會 | Accuphase | B&W | Burmester | Denon | Jadis | KEF | KRELL | Luxman | Marantz | Nuforce | OPPO | Pioneer | TEAC | WEISS | News
News | Blog | 其他
其他 | 所有 |
影音天地主旨 ﹝請按主旨作出回應﹞ | 寄件者 | 傳送日期 |
[#1] 點解用bi-amp D聲仲差個Single Amp? 我有兩套Amp: 1.All Tube : Pre amp & Mono Block 2.Integrated (with tube preamp ): with Pre out 試玩 bi-amp ( 個tube pre-amp 用唔到 !) :- CDP---> Integrated Amp---> Speaker Tweeter Integrated Amp Pre-out ----> Mono Block ---> Speaker Bass. D聲差過兩套Amp任何一套. 有無駁錯?點解? 請幫幫手。 |
winning11u23 正式會員 202.xxx.xxx.135 |
2008-11-03 18:00 | |
|
[#2] 點解用bi-amp D聲仲差個Single Amp? 玩bi-amp 最好還是用相同的power amp ,否則很難玩 |
nanoriver 正式會員 59.xxx.xxx.251 |
2008-11-03 18:05 |
[#3] 點解用bi-amp D聲仲差個Single Amp? 無錯, 1 + 1 =/= 2 |
HelloMorning 正式會員 202.xxx.xxx.6 |
2008-11-03 18:16 |
[#4] 點解用bi-amp D聲仲差個Single Amp? bi-amp need a lot knowledge and experience playing single amp first ! |
hifi oldman 正式會員 222.xxx.xxx.223 |
2008-11-03 19:03 |
[#5] 點解用bi-amp D聲仲差個Single Amp? When you play bi-amp, it is better to use same amps. I found even using amps of same brand, same vintage but of different power can produce a not so satisfactory result. Some people use mixed amps., and mixed cables to "校聲", the chance of success, in my opinion, is very unlikely. |
yukclee 正式會員 203.xxx.xxx.245 |
2008-11-03 19:14 |
[#6] 點解用bi-amp D聲仲差個Single Amp? the outputs of your integrated amp and the monoblocks are different, given the same input. so either high freqquencies are more intense or bass more intense. this would distort the uniformity of the frequency response. |
cpu8088 正式會員 220.xxx.xxx.117 |
2008-11-03 19:21 |
[#7] 點解用bi-amp D聲仲差個Single Amp? 即係無得玩,Thank you. |
winning11u23 正式會員 218.xxx.xxx.158 |
2008-11-03 23:10 |
[#8] 點解用bi-amp D聲仲差個Single Amp? Wrong setting! Your mono block has no gain control I assume so the bass and treble are not correctly proportioned. Try this: CDP---> Tube Pre using a 1 to 2 RAC plug (in SSP about $20 each)---> Output 1: Integrated Amp ----> Speaker Treble. Output 2" Mono Block ---> Speaker Bass. Then use the Int. Amp volume to adjust the treble proportion by playing different music. Mark the position and turn to that position each time you need to power on/off the system. I use similar setup and it works perfectly. Just that my pre-amp is a digital one. |
jefftse 正式會員 58.xxx.xxx.197 |
2008-11-04 06:20 |
[#9] 點解用bi-amp D聲仲差個Single Amp? 同一價格,一部single amp正過biamp |
aheung 會員 219.xxx.xxx.130 |
2019-01-30 10:24 |
[#10] 點解用bi-amp D聲仲差個Single Amp? 點解?, 點解?, |
254mm 正式會員 58.xxx.xxx.164 |
2019-01-30 10:42 |
[#11] 點解用bi-amp D聲仲差個Single Amp? 有相位差就高中低音單元唔夾得好,喇叭的結像點會完美無瘕地去成形呢!根本果套音響系統未有達到正常工作狀態,所以咪引致咗衰聲 最後修改時間: 2019-01-30 11:51:49 |
bcagl 正式會員 182.xxx.xxx.27 |
2019-01-30 11:48 |
[#12] 點解用bi-amp D聲仲差個Single Amp? 靈敏度不同都是問題, 須則同步左Volume, 合併,同mono amp輸出功率不同, 就算一樣Amp都要時間去調教, 並非轉變到Bi Amp就一定好左, 例子,類似RCA轉玩XLR寄望即時會變好,往往失望而回粗聲等等,好多時不明所以,XLR同RCA是兩個層面, 再調整系統是必須,講番Bi Amp道理都一樣 利伸Bi Amp使用中 |
cashotline 會員 14.xxx.xxx.140 |
2019-01-30 12:15 |
[#13] 點解用bi-amp D聲仲差個Single Amp? Ching you may want to try single amp with double bi-wire and see whether it sounds better or worse (then single wire with jumpers). If you are not using the same brand and model of speakers cables then this may be 1 of the reasons. |
MLfans 會員 165.xxx.xxx.99 |
2019-01-30 13:08 |
[#14] 點解用bi-amp D聲仲差個Single Amp? You need 2 amp that is the same. I use vertical setup with an active crossover, the gain in the crossover can balance the high and the low. |
erawdech 正式會員 116.xxx.xxx.217 |
2019-01-30 13:56 |
[#15] 點解用bi-amp D聲仲差個Single Amp? 2部衰声既Amp,出來衰声會Ⅹ2 |
Hardcore33 正式會員 182.xxx.xxx.37 |
2019-02-07 20:05 |
按照傳送日期顯示:由舊至新 由新至舊 |