影音天地主旨 ﹝請按主旨作出回應﹞ 寄件者 傳送日期 由舊至新 由新至舊
[#1] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
Infinity Black Widow or sme series III s

現有唱頭: Sumiko Pearl / Grado Blue

現有Phono amp 只有MM放大
jacky_fong
個人訊息 正式會員
218.xxx.xxx.147
2018-04-30 18:17
[#2] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
這兩支都曾擁有和玩過,要回頭的,我會選SME III
ktli
個人訊息 會員
112.xxx.xxx.64
2018-04-30 18:38
[#3] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
我以前買個唱盤跟支3s臂反尼即放!

揾支grace臂玩吓仲好!

最後修改時間: 2018-04-30 20:28:08
009terry
個人訊息 會員
14.xxx.xxx.47
2018-04-30 20:25
[#4] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
GRACE AND SME were once installed to LINN LP12 before they designed their own one with the Japanese.

And I think The Infinity Black Widow has a sudden surge in demand which sometimes go as high as £250-350!!! Have we missed something?

I am using the GRACE with ACUTEX MM cart which I set It to 0.9G.





最後修改時間: 2018-05-01 02:08:40
fotheringay
個人訊息 會員
86.xxx.xxx.193
2018-05-01 02:05
[#5] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
雖然自己也用雞屎707,但更喜歡這品牌的單點臂。這唱臂的最大缺點是那接線,接到唱臂那接頭和一般的不同(反過來的),不能隨意換線。
ktli
個人訊息 會員
112.xxx.xxx.64
2018-05-01 08:33
[#6] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
接頭在ebay有售,反來自己Diy便是! 問題不大!
自己係用grace 840裝在lenco l75上 輕壳+mm
如果用mc就要去到grace嘅707或747了
至於black widow都係唔錯嘅!



最後修改時間: 2018-05-02 13:36:10
009terry
個人訊息 會員
14.xxx.xxx.167
2018-05-02 13:29
[#7] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
有事要請教fotheringay師兄!
請問你加高了轉盤外仲有甚麼辦法張低頻諧減至最小?
009terry
個人訊息 會員
14.xxx.xxx.167
2018-05-02 13:39
[#8] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
Hi Terry,

I use Blutac stack inside the heavey platter.

Some suggest using the spry insulation foam.

Or look for DIY flywheel with different materials found in ebay or web.

I hope this help.

fotheringay
個人訊息 會員
86.xxx.xxx.253
2018-05-02 14:15
[#9] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
with lenco, better house the motor onto a plinth where you can dissipate the energy away. But also service the motor too.
charlie
個人訊息 會員
221.xxx.xxx.187
2018-05-02 14:49
[#10] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
謝謝fotheringay師兄幫助! 我上去找找吧!

小弟已經做了可做的改良辦法例如洗軸+靚的啤零油,調整過摩打的諧震,六層甲板木座,效果正面,總是差丁点!

最後修改時間: 2018-05-02 15:08:29
009terry
個人訊息 會員
14.xxx.xxx.167
2018-05-02 15:04
[#11] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
Terry,

I am sure you are aware the PTP project and I have been tempted for sometimes.

There are also talks about tweaking the springs to reduce the resonance.

The idea of “motor island” has also been discussed but I don’t know how the result presents.

The beauty of Lenco is the unlimited tweaking.

fotheringay
個人訊息 會員
81.xxx.xxx.82
2018-05-02 17:49
[#12] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
slate is the best material
charlie
個人訊息 會員
221.xxx.xxx.187
2018-05-02 18:28
[#13] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
fotheringay師兄! PTP當然有留意過,
至於你之前提過的三條彈簧是指原掛在底盤上掛摩打的彈簧? 可以調的嗎? 現在有兩個問題要解決,1/摩打本身産生的震盪,2/轆同轉盤摩擦得出的諧震!
Lenco係個好玩好聲嘅唱盤尼! 如果有各路高手可分享吓玩好Lenco盤嘅心得請分享吓心得...做福一衆Lenco迷就感恩了!

回charlie師兄!"石板"我接觸過两個直驅盤ㄧ是米高另ㄧ個是山水,但兩個我都無咩好感! 死實!

最後修改時間: 2018-05-02 20:11:54
009terry
個人訊息 會員
14.xxx.xxx.167
2018-05-02 19:47
[#14] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
I too had used a slate plinth for a short while, though not the prettiest.

It was cheap as it only costs me £2!!

I found it when visiting a charity open garden and I asked the house owner what was he doing with the slab of slate. He said nothing at all!

He told me I could have it for £2. I know there is a company selling bespoke slate but it could be expensive.

Soundwise I have no preference to it perhaps due to the fact that it isn't very thick, certainly heavy though.

There is one person and his name is Daiwok whom I believe is the expert with Lenco. He is one of the Lenconheaven administrators from Hong Kong and I think he should be able to share his expertise.

I would recommend you should visit Lencoheaven if you haven't done so. There are bucket lots of information which are extremely helpful.

I also made one solid plinth with oak. I think the result is quite good.









最後修改時間: 2018-05-03 08:15:56
fotheringay
個人訊息 會員
86.xxx.xxx.63
2018-05-03 08:13
[#15] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
fotheringay師兄!
Lencoheaven最早期都有上過,換油及修復都在這個網站看到,所以行動順利很多! 有時間的話我會再造訪佢謝謝!

石板我覺得重未解決到個根本問題!

最後修改時間: 2018-05-03 09:49:46
009terry
個人訊息 會員
14.xxx.xxx.167
2018-05-03 09:34
[#16] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
Terry, you know me, i sold you the Audio Technica 7V. Me and Daiwok has yet to finish our motor controller for the Lenco...sigh...
charlie
個人訊息 會員
14.xxx.xxx.91
2018-05-04 09:14
[#17] 請教: 唱臂決擇, Infinity Black Widow vs sme series III s    
當然記得你la!你係Chi?
你意思係...摩打個問題未解決?
之前找過David佢教咗我点樣可以張摩打嘅諧震透過調整軸芯同鋼片芯之間嘅距離達致最佳的諧震点!但盡了人事!只欠丁点!
009terry
個人訊息 會員
14.xxx.xxx.167
2018-05-04 13:37
按照傳送日期顯示:由舊至新由舊至新  由新至舊由新至舊
最新資訊 - 影音
光城精工推出全新汽車音響專用接地盒 ve-02 2021-01-26

最新資訊 - 影音
顛覆傳統,KEF 發布首個採用 Uni-Core™ 技術的超低音喇叭 KC62 2021-01-24

最新資訊 - 數碼
Wemo WiFi 智能插頭集中管理家居裝置 2021-01-23

最新資訊 - 數碼
全新 OPPO Reno5 系列正式抵港 升級 AI 人像錄影功能 創造影像錄製新樂趣 2021-01-23