談天說地主旨 ﹝請按主旨作出回應﹞ 上頁 首頁 | 寄件者 | 傳送日期 |
[#41] 有無試過搵人上門洗冷氣? 有冇洗室外呀? 既然內面甘污joe, 外面可能巳很難過風 最後修改時間: 2019-09-24 10:55:49 |
phil.ng 會員 223.xxx.xxx.7 |
2019-09-24 10:53 | |
|
[#42] 有無試過搵人上門洗冷氣? Worx tool is fine, got the 120mm wheel cutting saw and hammer drill.(not used often) 20V dc system should be OK for home application, though not as powerful as 220V ac system. Price would be in the order of $1,000 due to high battery price.(Taobao) Pressurized hand pump is not exactly for cleaning but for spraying chemicals (bleaching solution) into the coil, wait and then use tooth brush and cloth to assist. Then rinse. The exercise can be conducted once every few months, not few years, for effective disinfection.(not exactly to improve cooling) So the setup must be simple. Simple illustration, faster than watching Youtube. http://www.how01.com/article_54.html How much to invest is dependent on the initial cost and also payback period, nos.of units involved and frequency of cleaning.(would become slack after a few months) 最後修改時間: 2019-09-24 11:04:33 |
alexanderkoo 正式會員 58.xxx.xxx.161 |
2019-09-24 10:59 |
[#43] 有無試過搵人上門洗冷氣? >有冇洗室外呀? 佢又話唔洗喎!! |
明天的明天 正式會員 116.xxx.xxx.32 |
2019-09-24 12:02 |
[#44] 有無試過搵人上門洗冷氣? 自已用支自拍影下就一目了然 外面如多塵,浪廢電力,又易過高壓力,compressor短命 最後修改時間: 2019-09-24 13:33:27 |
Phil.ng 會員 45.xxx.xxx.233 |
2019-09-24 13:32 |
[#45] 有無試過搵人上門洗冷氣? 我望個外機又唔係積哂塵果D, 都ok既 |
明天的明天 正式會員 116.xxx.xxx.32 |
2019-09-24 14:43 |
[#46] 有無試過搵人上門洗冷氣? Cleaning the outdoor unit is fine but would need scaffolding in most cases. (unless installed at Balcony concrete floor/preformed concrete opening)Besides, the supporting aluminium framework is too flimsy to hold another man. I replaced outdoor fan in situ(needed "peeling"of the casing), capacitor, and compressor(could turn on but clogged capillary tube was the problem) The mild steel welded cage was constructed to BDD's requirement. So, quite safe AFA loading is concerned. Still needed the nerve to work outside high rise building. The conclusion is don't put too much money on the indoor unit only, simply having disinfection or removing dirt once for a while. The only effective means is coil water(ortho-phosphoric acid) but not for novice. 最後修改時間: 2019-09-24 16:44:38 |
alexanderkoo 正式會員 219.xxx.xxx.38 |
2019-09-24 16:43 |
[#47] 有無試過搵人上門洗冷氣? 部大金室外機超過十年唔覺污糟. 最後修改時間: 2019-09-24 18:12:49 |
S.Chan 正式會員 42.xxx.xxx.159 |
2019-09-24 18:12 |
[#48] 有無試過搵人上門洗冷氣? 背面才是入風位,也是最污 上相看看? |
Phil.ng 會員 45.xxx.xxx.233 |
2019-09-24 18:32 |
[#49] 有無試過搵人上門洗冷氣? oh...係喎. 得閒試吓影. |
S.Chan 正式會員 42.xxx.xxx.159 |
2019-09-24 18:39 |
[#50] 有無試過搵人上門洗冷氣? Must have dirt since the condenser coil is at the air suction side, hence lower inlet velocity. One newer unit(condenser placed inside washroom) had dirt/dust all over the coil as if it were a kind of air filter.(hence A/C not cool, current was a bit higher)Dirt layer could be peeled off by hand. But for room cooler, it's at the fan discharge side, much cleaner in having self-blasting effect. But the water after rinsing was still very dirty, may come from the bottom chassis only. Won't recommend coil water to remove the oxidation as shown on photo since it's already 10 yo, can't really help too much. Topping up of R22(?) might be useful after gauging the suction pressure and current measurement. A pressure vessel is designed to have leakage rate per annum. 最後修改時間: 2019-09-25 07:50:53 |
alexanderkoo 正式會員 219.xxx.xxx.159 |
2019-09-25 07:50 |
[#51] 有無試過搵人上門洗冷氣? 我每隔一丶兩年洗一次,流出來啲水灰黑色的。 一件電器放係到唔用都勁多塵,更可況係一件不斷吸風的冷氣 |
dttmtong 正式會員 45.xxx.xxx.71 |
2019-09-25 08:10 |
[#52] 有無試過搵人上門洗冷氣? 冷氣我試過自己拆自己通出水喉,結論係錢真係要俾人賺的。大熱天時浄係拆丶裝都身水身汗 |
dttmtong 正式會員 45.xxx.xxx.71 |
2019-09-25 08:13 |
[#53] 有無試過搵人上門洗冷氣? Wrap the fan motor with plastic bag and cellophane tape, don't think the motor is totally enclosed.(IP54) Once, the outdoor unit insulation was bad after cleaning, needed to strip down the motor, exposing the winding and dry out with heater. Check the capacitor terminals for any signs of heating, most vulnerable to failure. Already replaced caps a few times over the years.(polypropylene type from RS) Topping up of R22 refrigerant after measurement>>>cleaning alone(not for room cooler which is basically a gimmick) Won't recommend DIY for R410a refrigerant, the working pressure is too high(stalling already 20bar, close to 300 psi, suction running 10 bar) and any mal-operation(tripping of compressor), the back pressure might burst the can having no non-return valve.(should use stronger cylinder tank but overpriced) Besides, R410a is a mixture and in order to achieve the correct composition, one would need to add the refrigerant in liquid form at the suction side, not at discharge.(liquid can kill the compressor) Must add very slowly for complete vaporization. This is tricky. |
alexanderkoo 正式會員 219.xxx.xxx.159 |
2019-09-25 08:47 |
[#54] 有無試過搵人上門洗冷氣? 小弟甘岩尼期做冷氣科,成日洗分體,妟少少收工可以分享 diy 。 |
jobim888 正式會員 141.xxx.xxx.225 |
2019-09-25 18:01 |
[#55] 有無試過搵人上門洗冷氣? Maintenance has 2 aspects, periodic maintenance(namely cleaning and disinfection, physical checks, can be DIY) once every few months and overhaul work(chemical cleaning/rust removal/check refrigerant with a view to restoring to factory spec. at least up to 90%) once every few years. Without overhauling the outdoor unit, the chance of success for the latter is low. Cleaning indoor unit only at high cost is another gimmick, same as adding refrigerant to room cooler and lubrication years ago. Of course, there is repair work, say fan/capacitor/PCB replacement. 最後修改時間: 2019-09-26 08:23:17 |
alexanderkoo 正式會員 58.xxx.xxx.213 |
2019-09-26 08:19 |