談天說地主旨 ﹝請按主旨作出回應﹞ 上頁 下頁 首頁 尾頁 | 寄件者 | 傳送日期
![]() ![]() |
[#481] DIY 天堂 第二部。 ![]() |
呀金![]() 223.xxx.xxx.71 |
2024-04-04 03:07 | |
|
[#482] DIY 天堂 New copper tube sensor is of short cable length suitable for AC. Dried out the original one, it's 5k, potted by epoxy and re-used. Can buy longer length 0.5 or 1m. Or simply old cable+new sensor with joints. When AC can run for a while as if it were normal, with cooling, then tripped with flashing light. It's usually this sensor problem due to water ingress. If icing at coil, leaking refrigerant causing sensor to trip. So, sensor is normal. ![]() 最後修改時間: 2024-04-04 07:00:48 |
alexanderkoo![]() 223.xxx.xxx.117 |
2024-04-04 06:45 |
[#483] DIY 天堂 Water spray doesn't work, only lamp illumination. Open it up and there is voltage at motor. Dissemble the pump and motor. The latter can run. Pump problem. Got a complete unit at $22. Parts kept as spare, Outer casing dumped ![]() 最後修改時間: 2024-04-06 07:32:12 |
alexanderkoo![]() 223.xxx.xxx.179 |
2024-04-06 07:30 |
[#484] DIY 天堂 冇 "填補空隙",這種打膠塞的做法不耐用,唔合格! ![]() 最後修改時間: 2024-04-08 13:17:37 |
0925![]() 42.xxx.xxx.96 |
2024-04-08 13:17 |
[#485] DIY 天堂 |
0925![]() 119.xxx.xxx.242 |
2024-04-11 23:31 |
[#486] DIY 天堂 買了解凍板,有點用,食材-0.2C,室溫25.1C, ![]() |
alexanderkoo![]() 223.xxx.xxx.166 |
2024-04-13 07:06 |
[#487] DIY 天堂 早四個月前裝的一匹冷氣機,天氣熱再度電流,正常,沒有漏雪種,舊機重用,這個拑表,專為冷氣而設,很好用,可度起動電容數值,但電流4A,再上400A,無言,可度出風溫度(駁線有正負方向,熱偶原理,颇準)反而鐳射槍顯示多種温度 ![]() 最後修改時間: 2024-04-13 07:19:03 |
alexanderkoo![]() 223.xxx.xxx.166 |
2024-04-13 07:17 |
[#488] DIY 天堂 Panasonic water flosser having leaky tubing. Dissemble the handle and cut the faulty tube by a few inches. Two small holding tabs and spring fall apart. Take time to figure out how to put them back for holding the flosser tip. For waterpik, can buy replica handle with tubing on Taobao. ![]() 最後修改時間: 2024-04-14 10:08:25 |
alexanderkoo![]() 223.xxx.xxx.166 |
2024-04-14 10:07 |
[#489] DIY 天堂 ![]() ![]() 最後修改時間: 2024-04-14 18:12:33 |
0925![]() 219.xxx.xxx.57 |
2024-04-14 18:11 |
[#490] DIY 天堂 |
0925![]() 119.xxx.xxx.125 |
2024-04-17 07:18 |
[#491] DIY 天堂 ![]() ![]() ![]() 最後修改時間: 2024-04-26 13:06:09 |
0925![]() 116.xxx.xxx.172 |
2024-04-26 13:05 |
[#492] DIY 天堂 用超市貼紙換的電飯煲用幾年后個內膽花咗,¥38 買咗個 304 不鏽鋼的。 ![]() 直徑和高度冇問題,304 個底太平 ![]() 電飯煲個 heater plate 有個彎位 ![]() 拆出來睇下可唔可以磨平個彎位 ![]() ![]() ![]() 結論:要磨低差不多 1 cm 同條內藏發熱線好接近,就算用得熱力都不均勻,唔搞喇。 ![]() 剛淘咗一個 316 不鏽鋼內膽的電飯煲,不過 3L 的大好多(2L 的衹有304內膽的) 最後修改時間: 2024-05-01 16:33:23 |
0925![]() 119.xxx.xxx.175 |
2024-05-01 16:18 |
[#493] DIY 天堂 >>超市貼紙換的電飯煲個內膽花咕咗 咁黑仔?不過也無需太在意,個D cheapy 野,吾花都極可能用一兩下就花。 304 煮飯會有D黐,湯水燜燉個D無問題。 |
lym![]() 193.xxx.xxx.42 |
2024-05-01 16:21 |
[#494] DIY 天堂 #492 + 1 老婆拼多多找到賣 ¥196 的,如果316內膽的唔係賣得咁平,我就拎 #492 個304內膽去日本城配電飯煲。 ![]() 最後修改時間: 2024-05-01 18:14:45 |
0925![]() 119.xxx.xxx.175 |
2024-05-01 18:07 |
[#495] DIY 天堂 #494 + 1 ABS 外殼 ![]() 內層 316,外層304,如果 3-ply 中間夹鋁效果可能好啲 ![]() 826g 頗重 ![]() ![]() ![]() 最少煮兩嘜米,試煮一嘜落多咗水 ![]() 比想像中易清潔 ![]() 最後修改時間: 2024-05-04 16:56:47 |
0925![]() 116.xxx.xxx.4 |
2024-05-04 16:43 |
[#496] DIY 天堂 #495 留意最好買個內蓋可以唔駛工具就拆得,否則可能好易收藏污糟嘢 |
new68u![]() 221.xxx.xxx.89 |
2024-05-04 17:08 |
[#497] DIY 天堂 類似呢啲可以成塊拎起嚟洗 ![]() |
new68u![]() 221.xxx.xxx.89 |
2024-05-04 17:12 |
[#498] DIY 天堂 ![]() 最後修改時間: 2024-05-04 18:14:47 |
0925![]() 116.xxx.xxx.4 |
2024-05-04 18:14 |
[#499] DIY 天堂 #495 + 1 第2次(正式煮俾屋企人食)煮飯,今次水量啱,飯熟后 keep warm > 15分鐘,而家好少飯粒 "痴" 住內膽,沖凍/暖水抹一抹就乾淨晒,呢個電飯煲好值得買,而家告別所有有易潔塗層的食具喇! ![]() 最後修改時間: 2024-05-04 20:22:27 |
0925![]() 116.xxx.xxx.4 |
2024-05-04 20:17 |
[#500] DIY 天堂 #498 + 1 ![]() 最後修改時間: 2024-05-04 23:47:03 |
0925![]() 116.xxx.xxx.4 |
2024-05-04 23:46 |