| 談天說地主旨 ﹝請按主旨作出回應﹞ | 寄件者 | 傳送日期
|
| [#1] 部老爺AV amp Onkyo 696壞咗 今日睇睇吓電視，突然間部amp熄咗， 再開返就變成以下畫面， 照住上網嘅方法reset都冇用 唔知有冇高手指教一下  |
MinnaNoTabo 正式會員58.xxx.xxx.106 |
2026-04-12 22:35 | |
|
|
|||
| [#2] 部老爺AV amp Onkyo 696壞咗 If your Onkyo TX-NR696 is halted, unresponsive, or stuck at a specific volume (such as -1 dB), it is likely experiencing a firmware glitch, a protection mode trigger, or a network stack issue. Here are the recommended steps to resolve this issue based on Onkyo troubleshooting protocols: 1. Perform a Hard Reset (Most Likely Fix) If the unit is operating erratically, restarting it can resolve the issue. Method: While the unit is on, press and hold the ON/STANDBY button on the front panel for at least 5 seconds. Alternative: Unplug the power cord from the wall outlet, wait 60 seconds, and plug it back in. Onkyo Onkyo +1 2. Check for Protection Mode (Amp Diag Mode) If the volume is stuck and the unit refuses to play sound, it may have entered a protection mode due to an internal error, often caused by speaker wires touching or overheating. Action: Turn off the unit and check the back to ensure no positive and negative speaker wires are touching (bare wire shorts). Overheating: If the unit is hot, let it cool down. Consider adding a USB-powered fan if the unit is in a tight cabinet. 3. Clear/Factory Reset (If Frozen) If the display is frozen, you may need to factory reset the unit to clear the error. Method: With the unit in standby, hold down the CBL/SAT button on the front panel and press ON/STANDBY. "Clear" will appear on the display, and the unit will reset. Note: This will erase your calibration and settings. |
new68u 會員 118.xxx.xxx.176 |
2026-04-12 22:58 |
| 按照傳送日期顯示:由舊至新 由新至舊
|
